Set up raspberry pi zero12/19/2023 ![]() The 3b+ enables the mass storage and network boot options by default. To set that bit requires a special SD card. The Raspberry pi 3B adds USB mass storage and network boot options but unfortunately they need to be enabled by setting a bit in the one time programable memory on the SoC. If there are already Pi boot files on the SD card then I belive you may have to be careful when you insert it since the Pi A series don't have the special circuitry to suppress the SD card interface that the compute module has. ![]() You can find instructions for the compute module flasher utility at. On a model A, A+ or Zero I belive you can use an appropriate USB cable (A to A for the A/A+ A to micro B for the Zero) cable along with the flasher utility intended for the compute module. You may well find that you can use a camera or an older smartphone as a card reader (newer smartphones tend to use MTP rather than mass storage, so they are not suitable for this) to write your card. ![]() The only things these models can boot from out of the box is a SD card. That basically leaves you trying to connect a keyboard and mouse via Bluetooth. You could always use a USB extender hub, but then that's more to carryincluding another power supply. On a B, B+, 2B or 3B you can't do it without something to write the SD card. The Zero has a limited number of USB connectors on boardjust one, if you allow for the power connector, which obviously means you have limited connection options.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |